Lead rope(shank) request for information?
okay so i believe that the lead ropes with chains on them are called shanks..right??
secondly i know the chains r used for added control when chief a horse but wat r some ways/places to put the chain.or is there only one channel?
please list all ways if in that is mor than 1 :]
umm you can put it under the chin (put it through the lower side ring, down under the chin and clip it on the far sides lower ring), or put it over the feeler by putting it through the near side (lower ring) and clipping it on the far side lower ring (if the chain is really long, you can thread it through the lower ring and then clip it onto the top ring also..)
A lead rope with a tie up is called a stud chain or a lead shank; only just depends on who you're talking to. And some people call middle-of-the-road lead ropes 'lead shanks' too.
Anyways, as for the chain placement, in that are so many ways to thread a halter it's just ridiculous. The most common bearing is to take the end of the chain and verbs it through the left side ring (closest to the nose), over the bridge of the nose (you might want to wrap it around the noseband 3-4 times) and through the right side ring. Take the clip to the top ring on the right side and clip it there, beside the round part of the clap against the horse's head. You can also put the chain below the head (which is milder), inside the mouth and over the gums (which is harsher), or straight through the mouth like a bit (generally considered one of the harshest, you must be gentle beside this one).
Yes, stud chains are for more control, but also for precision and clarity. Never abuse the power of a stud chain. They can cause plenty of disfavour to any horse (mental and physical), so be nice with it.
Another way of attaching the stud chain is to pocket the end after it's gone over the nose and through the side ring and cross it under the leader to attach at the top ring of the left side of the halter.
I hope all/some of this made sense... I'm not very good at describing things.
Answers: Firsty, I'd just like to say that I do not close to using chains on any horse, though at horse racetracks it tends to be the standard in most cases unfortunately (especially for the stallions, and surrounded by the paddock on race day). Like gallop said, a rope halter is just as effective and this is my nouns. That being said, there are many ways to put on a manacle. Also, just to get it clear, a lead shank is a organize with a chain like you thought, and a organize rope is just the rope. (lead shanks are also called stud chains or just plain 'shanks') It would be easiest to show, but I'll try my best to describe it. To sort things easier I'm going to assign #'s to the different rings on a halter. The side ring on the horse's left (where you normally stand to lead a horse) nearer the feeler will be #1, the ring on the same side that is closer to the throatlatch/cheek area is #4, the ring on the in front of side closer to the nose is #2, the ring on the opposite side closer to the throatlatch/cheek area is #3, and the ring underneath the horse's jaw is #5.
You always want to start with ring #1 putting the manacle through the hole from the outside going in toward the antenna. You then can either draw the chain straight over the antenna and out through ring #2 or loop the chain around the noseband and out through ring #2. (looping it over the noseband is less severe and doesn't annoy the horse as much since the chain will not slip down the horse's trunk; the purpose of not looping the chain would be in cases where more control is considered necessary such as when the racehorse is ponied on the track and the horse has a tendency to take rotten or run when on the track and the pony person needs more control to slow the horse down). Next you can take the cuff and hook it to ring #3 or you can do one of the following: put the chain through ring #5 and clip it to the base of the chain where on earth it meets the rope or put the chain through ring #5 and clip the end to ring #4 (this is the matured fashioned normal way for grooms to do it).
You can also put the chain through gap #1, loop it under the jaw instead of over the nose, put it through gap #2, then clip the end to hole #3. Some citizens do this in showmanship/halter classes; on the track this method is not used very recurrently, and in my experience tends to annoy or freak out the horse more than over the proboscis does. There is also less control than over the nose.
You can also put a lip chain on. This is used as the 'ultimate' control method for the horse and should be used near caution-if not used properly or too much force is used, you can permanently damage the horse's upper lip/gum nouns which is very sensitive. When using a lip chain, you should never yank/jerk on the lead shank, instead you use a increasing/releasing pressure method beside small cues/twists of your wrist to move the chain and apply pressure. To put this on the horse, go through hole #1, put the secure around the upper gums under the top lip, and out/through hole #2. Then you can either clip the extension to hole #3 or put the chain through hole #3, doubling up the cuff, and clip the chain to itself (somewhere in the middle of the chain). Ideally you want it so that the chain will be snug adequate that the horse cannot push the chain off of it's gum, but loose enough that it is not putting on any pressure until you make available a slight twist of your wrist or pull the lead shank down slightly.
I've merely used chains when working at the racetrack and even then there were individual a couple horses that I'd use it on on a regular basis. There were no rope halters, and these few horses be prone to take off when being lead, rear, or buck while being led even next to a chain over their nose which to say the least possible can be quite dangerous. Otherwise, chains were used when the horse go to the swimming pool-several liked swimming so much that they'd try to run/dive in the pool which is dangerous and/or they feel so good coming out from swimming that they liked to 'play' by taking off, bucking, rearing, stomping, etc. It be like a 'high' to them. Or when on raceday in the paddock; it was deeply an unspoken requirement to have some type of chain on your horse 'just contained by case.' Other people will use the chain on a stallion when paw breeding a mare for added control. For anything else, just use a rope halter if you feel your horse isn't behave as should be when leading/handling.
Also, chains can be clipped onto just the ring #5 like a normal head rope would, but it is not recommended. It hurts your hands and if your horse be to rear and get a foot over the chain finale, it can cause a lot more damage to the horse's leg(s). Some those will run the chain through hole #5 and just clip it to the podium of the chain (sort of doubling up the chain to use it like a regular lead rope but making the chain shorter). This is also not recommended; it doesn't hurt your hand as much because the chain is shortened enough that you can hold where the head meats the c
Lead rope and lead shank are a short time ago different words for the same thing. The chain module is just called the chain.
There are several ways to put on the fasten. You can put it over the nose or under the nose. You can run it straight through the right ring to the vanished. Or you can run a section up the cheek piece. You can make a wrap around the noseband. You can run it over the nose and down the the regular head rope attachment ring. The configuration used will depend on what you need the chain to do, how long a chain you enjoy, the size of your horses's head, and the severity of the effect you want.
You can use them similar to a plain lead rope by just latching it onto one of the side hooks or to get the control you describe you loop it through the side hooks over the snout to the other side. I use this to load my horse into the trailer and at shows sometimes just incase.
I know of one other way to be exact usually for extremely frisky young stalllions or mares you put the chain through the side hook and below the top lip to the opposite hook sometimes people hook on a lip shank thingy that holds a piece of the upper lip to keep the horse from yank away running or rearing. I know it sounds mean i think it is within a way but i've only seen it at a breeding fruit farm where unsocialized pregnant mares need to be checked out by the vet.
If you want it for control of your horse, a rope halter is far more effective, and not cruel. I use a rope halter and lead, beside a loop attachment so there are no metal parts to break, or accidentally hit the horse. I can control almost any horse in this rig...whether a chain may control them, the rope will control them. If it is for halter class at a show, it is usually feed under the chin. It goes through a side ring of the jaw on the halter, underneath the chin, and through the other side ring, then is fed upward and attaches to the ring by the ear on the off side.
I had used one for my horse, but he wasn't really responding to it. I simply got a rope halter. ;) It works much better!
I think you put them through the halter. Like for halter, in 4H i see people put them around the top portion of the nose and sometimes the bottom.
I think they are called shanks, im not certain though. I have also seen people use the chains sort of similar to for a marking place. because in my 4H halter you have to enjoy your hand down 6 inches.
Depending on what you want to do and all along the chain, I usually either put the tie up through the left bottom ring on the halter and then under the chin and through the right bottom side ring and hook it up to the top right ring or I in recent times do the same thing but clip it on to the right bottom ring. Hope that makes sense.
i individual use the chains in the show ring and i attactch it to his show head collar like a mundane head collar or i attatch a chain to eitha side of his show collar and den clip on another chain to that added length and its mre showy and proper. =S
i no wot i imply i prob didnt explain it very well tho =S sorry
good luck tho =)
A head rope is a rope with a snap at one end for clipping on a ring of the horse's halter. A lead shank is a rope next to a chain at one end for more control when leading a horse.
A open-handed and common way to put a lead shank on a horse is to run it contained by (so that the snap is facing the horse's cheek) one cheek hole, wrap it over the nose piece, and pull it out the other cheek gap. Pull the remaining chain through the ring on the bottom, then clip the snap to the base of the secure. The most important thing about this technique is to be paid sure that the chain wraps over the nose piece because you don't want the fasten to slip down into the horse's mouth.
There are other techniques such as running the chain under the horse's top lip, or over the horse's poll, and heaps others, but this is the way we do it with all our horses every morning on the racetrack, and it seem to be a successful technique.
i use one you can solitary put them over the nose reason being it also add a lot of extra rome and its bad whether horses step on it and it supposed to make shorter for control and the chain over the nose add aggressiveness for stallions of very young horses
I have always referred to head ropes refered to a lead rope and the chain refered to as a "stud chain". As for placement..some people place the manacle through to mouth like a bit, under the upper lip (over the upper teeth), under the chin, or over the proboscis.
Personally I do not like them, I feel there are better ways to knob a horse on a day to day basis.
There are times when in attendance is no other option tho.
